With the increasing demand of panel furniture, panel CNC cutting machine is also welcomed by more and more furniture enterprises. Both woodworking carving machine and CNC cutting machine are wood processing machinery. Woodworking CNC cutting machine is nothing more than cutting and carving modeling. Ordinary woodworking carving machine can also do it. Why buy the cutting machine?

Many customers have such questions. The price of CNC cutting machine is much higher than that of common multi process woodworking carving machine. What are the advantages that make many customers choose woodworking cutting machine? Here is the difference between woodworking carving machine and CNC cutting machine. The difference between CNC cutting machine woodworking carving machine and CNC cutting machine 1. Common woodworking carving machine or multi process woodworking carving machine can cut materials.

But its bed structure and mechanical parts decide that it can't carry out the cutting work for a long time, otherwise it will cause the bed deformation and mechanical accuracy to be lower and lower. The bed structure and accessories used by the cutting machine are much higher than the woodworking carving machine, which can adapt to the long-term cutting work, and the speed is very fast.

Different from the control system used by woodworking carving machine, the CNC cutting machine can optimize the cutting software with numerous designs and layouts, improve the utilization rate of plates, and the software can automatically open sheets and materials, which is incomparable to ordinary woodworking carving machine.

Material machine and engraving machine are also different in plate fixation: the material cutting machine is basically based on vacuum adsorption table, which requires the addition of adsorption pump as a part of the increase in cost. Many customers will say when they buy the machine that it is very good to process the whole board with the adsorption table, but it will be very power consuming to process small pieces of board and start the adsorption pump, so they want the table with dual-purpose suction clamp, but there is a deviation in this cognition, and its adsorption effect is not as good as that of the full adsorption table.

Now the adsorption table is divided into zones, and small plates can open a single adsorption area to save electricity. For the adsorption pump, there are two kinds: air-cooled and water-cooled. The air-cooled adsorption pump is noisy, but the water-cooled adsorption pump needs to pay attention to antifreeze in winter, so you can choose the appropriate adsorption pump according to the local climate.